United States Stove Company 2200I Instruction Manual download pdf (Page 8)

8 Ussc

CHIMNEY SPECIFICATIONS

This appliance must be connected to a listed Stainless

Steel Liner, that meets UL1777, which extends from the

collartothechimneycapaccordingtothespecications

listed on the previous pages.

Chimneys perform two functions:

1. Asameansofexhaustingsmokeanduegaseswhich

are the result of fuel combustion.

2. The chimney provides “draft,” which allows oxygen to

be continuously introduced into the appliance, so that

proper combustion is possible. This stove relies on

natural draft to operate.

NOTICE: Always provide a source of fresh air into the

room where the stove is located. Failure to do so may

result in air starvation of other fuel burning appliances and

thepossibledevelopmentofhazardousconditions,reor

death.

Yourapplianceitselfdoesnotcreatedraft.Draftisprovid-

ed by the chimney. To achieve proper draft your chimney

must meet the three minimum height requirements de-

tailedingure8.Aminimumdraftof0.05w.c.(measured

inwatercolumn)isrequiredforproperdraftingtoprevent

back pufng, smoke spillage, and to maximize perfor-

mance. (Gauges to measure draft are readily available

at stove stores and are economical to rent or purchase.)

Factors such as wind, barometric pressure, trees, terrain

and chimney temperature can have an adverse effect on

the draft. The manufacturer cannot be held responsible

for external factors leading to less than optimal drafting.

Should you have a problem with inadequate draft, you

should contact a licensed heating and cooling contractor

for assistance in solving the problem.

IMPORTANT INSTALLATION POINTS

1. Size chimney ue to appliance collar. This stove re-

quiresaminimum6”diameterue.

2. Never connect this unit to a chimney serving another

appliance.

3. The chimney must meet all minimum height require-

ments.

4. Never use a chimney to ventilate a cellar or basement.

5. Contact your local building authority for approved meth-

ods of installation and any necessary permits and/or

inspections.

MASONRY CHIMNEY

Before using an existing masonry chimney, clean the

chimney, inspect the ue liner and make any repairs

needed to be sure it is safe to use. As mentioned previ-

ously,thisappliancerequiresacontinuousstainlesssteel

linerfromtheappliancecollartothechimneycap.Make

repairs before attaching the stove. The connector stove

pipeandttingsyouwillneedtoconnectdirectlytoama-

sonry chimney are detailed in the installation instructions.

If the replacechimneymustgothroughacombustible

wallbeforeenteringthemainchimney,consultaqualied

mason or chimney dealer regarding proper materials that

meetalllocalbuildingandreauthoritycodes.Theinstal-

lationmustconformtolocalbuildingandrecodesand

latest edition of NFPA 211.

If there is a cleanout opening in the base of the chimney,

close it tightly.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 19 20

Comments to this Manuals

No comments

United States Stove Company 2200I Instruction Manual Page 8

Comments to this Manuals

Related products and manuals for Fireplaces United States Stove Company 2200I