United States Stove Company BRECKWELL SPG9000 Instruction Manual Page 16

  • Download
  • Add to my manuals
  • Print
  • Page
    / 22
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 15
16 Ussc
THE FIRST FIRES
The rst few res in your new appliance needs to be small so as to cure the fresh paint and preserve it’s quality. To do
so, ll the pre-chamber with 1/2 charge (approximately 5-7 obs.) of premium wood pellets. Close the fuel lid and dump
fuel into main fuel chamber. Open the Viewing Door and light pellets. Close Viewing Door once the pellets have properly
ignited. Pull the primary control knob out to achieve a meduim burn rate. Never open the air control more than necessary.
Make sure that there’s enough air circulation while curing the stove. The odors could be present during the rst 3 or 4 res.
Never start your stove outside. You will not be able to see if you are over heating.
IGNITION
CAUTION:
NEVER USE GASOLINE, GASOLINE-TYPE LANTERN FUEL, KEROSENE, CHARCOAL
LIGHTER FLUID, OR SIMILAR LIQUIDS TO START OR “FRESHEN UP” A FIRE IN THIS
HEATER. KEEP ALL SUCH LIQUIDS WELL AWAY FROM THE HEATER WHILE IT IS IN USE.
HOT WHILE IN OPERATION. KEEP CHILDREN, CLOTHING AND FURNITURE AWAY. CON-
TACT MAY CAUSE SKIN BURNS.
Open fuel loading lid. Fill pre-chamber with pellets. Close lid and use fuel charging system to dump fuel into the main
fuel chamber.
NOTE: DO NOT add more than 15 lbs. of pellets into the pre-chamber or more than 30 lbs. of pellets into the main
chamber at one time.
Open the viewing door and see that pellets have fallen into the burnpot.
Squirt only a small amount of re starter gel on top of the wood pellets.
Light the re starter and allow the pellets to ignite. (Close the viewing door and latch securely).
Do not agitate the re during the ignition process.
There will be a transition period between startup and operational levels. As with a conventional wood stove, please allow
20 -30 minutes for stove to reach operation temperatures. During the 25 minute start up period, DO NOT agitiate the re.
OPERATION
DO NOT open viewing door during operation.
DO NOT open ash pan during operation – make sure the ash pan is properly sealed.
DO NOT actuate fuel charging system during operation unless fuel loading lid is completely closed.
When operating the agitator, be careful not to agitate too often or too much at one time. Pushing or pulling the agitator knob
approximately six (6) times should be sufcient. However, under different burn conditions or fuel quality, this number may
differ slightly. Experience burning your appliance will help you understand more of the amount to agitate during operation.
NOTE: This appliance does not have a “quick” shutdown method. Once the appliance has been charged with fuel, ignited
and burning, it will burn until all fuel has been consumed by combustion. Please note that once the re does cease, the
appliance may still be quite warm or HOT and could remain Hot for an undetermined amount of time depending on ring
conditions. Experience burning your appliance, will tell you how many pellets to put in the burn chamber in order to burn
for a desired period of time. This unit may run anywhere from 5-12 hours on a single 30lb charge depending on the air
adjustment setting and quality of fuel used.
You may use the below primary air settings as a good starting point when burning your new appliance. Please note that
these settings may vary depending on certain factors that may affect combustion.
Primary Air Settings
(Slide Damper is located on the right side of stove)
(Damper Adjustment: Pulling out on damper increases air)
Burn Rate Adjust Damper from fully closed
Low 1/4” (6.3mm)
Medium - Low 3/8” (9.5mm)
Medium - High 1/2” (12.7mm)
High approx. 3” (76mm)
CAUTION: Never alter the damper slide or the adjustment range to increase ring for any reason. Doing so could
result in heater damage and will void your warranty.
Page view 15
1 2 ... 11 12 13 14 15 16 17 18 19 20 21 22

Comments to this Manuals

No comments